Hydrologic Control Actuator

Pump Control Valves protect pumps and pipelines against any damage that may result from start / stop or flow surging caused by an electrical trip out by minimizing the pressure surges (water hammer) by slowly increasing or decreasing the velocity of the water.

Description	Unit
Face to face dimensions	Refer to Valve Dimensions and schematics
Body design	In-line
Pre-opening	6 mm (max 8 mm; min 5 mm)
Pressure rating	250 bar (max) working pressure
Design specification	ANSI B16.34
Solenoid voltage	24 VAC (other voltages may be specified)
Valve configuration	Globe type – taper poppet & seat

Size Availability	50 NB	80 NB	100 NB	150 NB	200 NB	250 NB	300 NB
Working flow rate (Max) *	15 ℓ/sec	22 ℓ/sec	40 ℓ/sec	64 ℓ/sec	113 ℓ/sec	177 ℓ/sec	255 ℓ/sec
* Suggested maximum flow rate, however 25% higher flow rate is achievable

Throttles and maintains the pump pressure when the downstream column is empty or partially full
Throttles the pump outlet when the pump is stopped to prevent water hammer
Can be maintained in line
High cavitation resistance due to poppet and cage design
Stainless steel and bronze internals with UHMWPE seals
External pilot valve
Cast steel body (galvanised body optional)
Low pressure drop across valve
High sealing integrity and dirt tolerance
Flanges and face dimensions to customer specifications
Closes to pre-open position if the electrical signal is lost
Manual override on actuator

Hydrologic Control Actuator

Related Products

Surge Anticipation Valve System

Non return Check Valve

Air Admittance Valve

Anti-surge Valve