PRODUCT RANGE DRILLING EQUIPMENT
  DRILLING EQUIPMENT

LONG HOLE DRILL RIG

PURPOSE

To drill orepass blast holes from the cross cut or from a cubby from the bottom up to a length of 60m

Also used for the drilling of drain and cable holes and travelling ways

FEATURES
  • Track bound
  • Operation from remote control stand
  • Automatic drill tube feed

SPECIFICATIONS
Drill rig size 3m Long
1.5m Wide
1.75m High

Drill angle

Flat horizontal to 90 ° vertical

Drill tube length

1.5m

Water consumption

3 to 4.2 l/sec
4 to 6.0 l/sec

80
100

Hammer
Hammer

Penetration rate

0.5m/min to 1m/min depending on rock type

Cage size

1.5m wide x 2.8m long

Excavation size 4m x 4m x 4m - drilling at 80 degrees
Power source - hydropower 18 MPa
Hole diameter 90mm - 165mm
Maximum ore pass size in single set up 2m diameter or square
“In the hole” hammer power output
12.5 kW

Hole length

70m max.

Please Note:

  • In the interest of improving products HPE reserves the right to change any specifications without notice
                 
| Back to top | | Print Page | | Send this page to a friend |